Show us your gear!

[barfle]

Yesterday I made another component addition to my rack, the Panamax MR4300 Line Conditioner, Noise Filtration, and Surge Protector. As always, have fun moving everything, but it takes some time.

Regards,

I feel your pain! I still don’t have the optical cable and the second HDMI cable run to my Oppo 105. My intent is to use the optical to my Surround Master and the HDMI for Atmos.

Yes, it takes time. Even when you’re retired.

 

[barfle]

Wow! A PDP-11. I used some of those in the 1970s.

It was ‘73 or ‘74. But all I got to do was turn in a deck and pick up the printout.

 

[par4ken]

Yes, it takes time. Even when you’re retired.

I used to get tired at work, now I'm re-tired at home, all over again!

 

[DuncanS]

My original intent was to fiddle around with arrays, so I just defined one that probably didn’t fit. I believe the computer was a PDP-11, but I was never granted access to it. I just had diagnostics that said the program was aborted by the operator. I eventually got it to run on the school’s computer by eliminating one dimension of the array and calculating one line, printing, calculate the next line, print, rinse and repeat. When I rewrote it in BASIC for my first PC, it ran the full 3D array witout complaint. I think I had 64k of memory - all that would fit, but damn, that’s a long time ago,

Wow! A PDP-11. I used some of those in the 1970s.

When I did my A-Level (so pre-Uni exams) in Computer Science, to do some machine code programming on one occasion we were allowed to directly toggle in our programs (via the front panel switches) into a PDP-8 - I think it was all in either Octal or Binary. I somehow managed to crash it, which meant it had to be fully rebooted via punch tape, which took them quite a while - I was not popular!

 

[PK]

I paid for Audyssey Mult-EQ X to be able to correct only the frequencies below 250/300Hz, and also to use the nice GUI of the software. I did the calibration once as I have not changed the set up since, but it was well worth the money. Room calibration is quite audible if well done and then validated by REW measurements. I would recommend it.

Did you try the $20.00 Audyssey App prior to getting the MultEQ-X program?

 

[Albert Dagger]

Did you try the $20.00 Audyssey App prior to getting the MultEQ-X program?

Yes, I did and I still have it installed. But the functionalities are quite limited. You can add curtains, and draw with your fingers on the screen a target curve, and it’s quite challenging. I much prefer MultEQ-X and the extra options available.