Show us your gear!

[doctors11]

When I installed cable channel around the walls and fired up the AVR, I was freaking out because the display would show AMP/SPEAKER.
Misinterpreting that as a short I tested every wire with a meter. Then I read the manual......
Every time the AVR's power cable is removed (soft reset) and then powered up again it shows that message.

I'm shopping for cable channel (raceway) now. Which one did you go with?

 

[mandrix]

I'm shopping for cable channel (raceway) now. Which one did you go with?

I bought it at Walmart online. Simplecord cable concealer it's called. It was the widest rectangular raceway I could find. Each box had six 25" pieces and had straight, corner, and T cpnnectors.
If you are meticulous, you can just squeeze in I think 6 pairs of 12 gauge speaker wire.

 

[doctors11]

I bought it at Walmart online. Simplecord cable concealer it's called. It was the widest rectangular raceway I could find. Each box had six 25" pieces and had straight, corner, and T cpnnectors.
If you are meticulous, you can just squeeze in I think 6 pairs of 12 gauge speaker wire.

Thanks. I've been looking at Legrand, D-line and Mono systems. I'll check yours out.

 

[alansanchez86]

The software is free.

It's about maximizing and optimizing the integration of your existing speakers and subs right now.

Yes, like Audessy, once set, you may not touch it again until some significant change occurs.

Thanks, the reason why I said that is because someone I know, a person who might calibrate my HT. nudged me into get the license of DIRAC live

 

[barfle]

I’ll have pictures once all this stuff shows up. I’m getting my first significant upgrade since I built the room, replacing my dear old Marantz 7701 pre-pro with a 7706 (get ‘em while you can - they still have MCH analog audio inputs), which has Atmos capability. I’m also getting an Emotiva 6-channel amp to replace the dear old Akai stereo amp I’ve been using for the rears.

I’ve had ceiling speakers since I built the room, waiting for the day when I could get the hardware to drive them.

My sister is making a quilt that I’ll use both as a aound absorption panel at the right-side reflection point. No idea when that’ll show up, but I’m fabricating some quilt holders for that element.